The support for the new Gamma pad has been furtherly enhanced. It does now fully support "signotec Content Signing" in both modes. Also many smaller issues have been fixed.
Please note: The Gamma pad is still only supported with a BETA version of the STPadLibNet which is not included in this setup!
Two new button sets for the signature devices are now available. These new sets contain wider versions of the buttons of set 1 and 2 for the pads Sigma, Omega and Gamma. Please note, that the icons of set 1 and 2 will be used for content signing. This is due to the fact that the headline is displayed between the buttons. Please also note: There are no new Buttons for the Alpha pad. The buttons of the Alpha are rather large already, so there is no space for even larger ones in most situations.
Due to the fact that the development of signoStorage is on hold for the time being the dialogs allowing the configuration of signoStorage in signoSign/2 are no longer visible. They will be reactivated if and when the development of signoStorage will be finished.
In some cases a certified time-server could make the signature data that much longer, that the reserved space in the document was too small. In case a certified time-server is used much more space will now be reserved. In addition a check was implemented giving a proper response if the space is insufficient.
Some minor fixes and corrections.
STPadLibNet: Updated to newest version. This included the following fix:
In some rare cases the button bar of the Alpha pad could be displayed two times. This has been fixed.
Setup: If a "SignPDF3.ini" is placed in the same folder then the setup file is located this "SignPDF3.ini" will be copied during the install process instead of the default one.